(1) RVS-DN 950-3000A, RVS-DN 1000V and RVS-DN 1200V must be operated with a bypass contactor. For usage without bypass contactor consult the factory.
(2) Preparation for bypass contactor is standard in RVS-DN 85-170A
(3) Only one option, either 3M or 3P or 3D may be installed in one RVS-DN
(4) Only one option, either 4 or 5 or 7 or T may be installed in one SRVS-DN
(5) All options must be factory installed in RVS-DN 8-72A
(6) Current transformers (CTs) for SI-DN950A and up are designed to allow installation within 1.5m from the RVS-DN (use the CTs for the RVS-DN only!)
(7) For more than one option indicate, for example: 8-9 for Harsh environment and preparation for bypass contactor. Ordering Example: RVS-DN rated 820A, mains voltage -230V, Control Supply voltage -115V, Control Input -115V, Modbus communication card, Analog card, Harsh environment treatment, preparation for bypass and standard front panel: RVS-DN 820 - 400 - 115 - 115 - 3M - 5 - 8 - 9 – S (note that 400V mains is for 230-400V)

Notes: Control voltage can be changed on site for RVS-DX up to 170A.

RVS-DX rated 170A, mains voltage- 230V, control voltage- 115V, Modbus communication card, Analog card, Harsh environment treatment and standard front panel:
RVS-DX170-400-115-3M-5-8-S
(note that 400V mains is for 230-400V)

Note: Control voltage cannot be modified on site.

RVS-DXM rated 840A, mains voltage- 230V, control voltage- 115V, Modbus communication card, Analog card, Harsh environment treatment, option 66 bus bars arrangement and standard front panel:
RVS-DXM 840 - 400 - 115 - 3M - 5 - 8 - 66 - S

(1) Only one Communication option from 3M, 3P, 3D.
(2) Only one option from: 4, 5, 6.
(3) You can install these options on site.
(4) You can install these options on site for 17A to 170A only. For 230A and up units supplied with fan as standard.
(5) Factory installed option.
(6) Only for 17A to 170A only.
(7) Only for 230A to 430A only.
(8) One option can be installed – either 33 or 66 or 36 or 63. Only available for 230A and above.

Notes: (1) Consult factory

Notes: (1) For DC control voltage or control inputs voltage - consult factory.

Notes: (1) For DC control voltage or control inputs voltage - consult factory.

Note: (Option “P” available only in vertical construction. For option “P” in horizontal construction – Consult factory)

Note: Only requires when front Modbus Comm. Port is needed - for example when Profibus is installed in the rear side.

(1) MIP MV1 is supplied with a resistor unit RU-7.
(2) MIP MV2 is supplied with a resistor unit RU-13.